A DESIGN SOLUTION FOR COMPACT SLOTTED WAVEGUIDE ARRAY ANTENNAS BASED ON SIW TECHNOLOGY
188 viewsKeywords:
Slot array antenna; Waveguide; SIW; Microwave.Abstract
Slotted waveguide array antenna is a crucial structure in microwave frequency antennas with many applications in radar and communications systems. Previously, slotted waveguide array antenna systems mainly used metal materials. The study of slotted array antenna based on the waveguided with SIW (Substrate Integrated Waveguide) technology is a novel approach. The paper presents the results of researching, designing, and manufacturing waveguide slot array antenna with low SLL using SIW technology in X-band. The results will be an essential basis for selecting a design solution for slotted waveguide array antenna by SIW technology to replace traditional metal slot array antennas in practical applications in X band radar antenna systems.
References
[1]. Gilbert, R. A., “Antenna Engineering Handbook”, Chapter: Waveguide Slot antenna Arrays, McGraw-Hill, 2007.
[2]. Rueggeberg, W., “A multi-slotted waveguide antenna for high-powered microwave heating systems,”.
[3]. D. Deslandes and K. Wu, “Integrated microstrip and rectangular waveguide in planar form,” IEEE Microwave Wireless Compon. Lett., vol. 11, pp. 68–70, Feb. 2001.
[4]. J. Hirokawa and M. Ando, “Single-layer feed waveguide consisting of posts for plane TEM wave excitation in parallel plates,” IEEE Trans. Antennas Propagat., vol. AP-46, pp. 625–630, May 1998.
[5]. H. Li,W. Hong, T. J. Cui, K.Wu, Y. L. Zhang, and L. Yan, “Propagation characteristics of substrate integrated waveguides—Numerical simulations and experimental results,” in IEEE MTT-S Dig., vol. 3, Philadelphia, PA, 2003, pp. 2049–2052.
[6]. D. Deslandes and K. Wu, “Single substrate integration technique of planar circuits and waveguide filters,” IEEE Trans. Microwave Theory Tech., vol. 51, pp. 593–596, Feb. 2003.
[7]. K.Wu, “Integration and interconnect techniques of planar and non-planar structures for microwave and millimeter-wave circuits—Current status and future trend,” in Proc. Asia-Pacific Microwave Conf. (APMC’01), 2001, pp. 411–416.
[8]. Elliott, R. S. and L. A. Kurtz, “The design of small slot arrays,” IEEE Trans. Antennas Propagat., Vol. 26, 214–219, March 1978.
[9]. Stevenson, A. F., “Theory of slots in rectangular waveguides,” Journal of Applied Physics, Vol. 19, 24–38, 1948.
[10]. Elliott, R. S., “An improved design procedure for small arrays of shunt slots,” IEEE Trans. Antennas Propagat., Vol. 31, 48–53, January 1983.
[11]. Elliott, R. S. and W. R. O’Loughlin, “The design of slot arrays including internal mutual coupling,” IEEE Trans. Antennas Propagat., Vol. 34, 1149–1154, September 1986.
[12]. Elliott, R. S., “Longitudinal Shunt Slots in Rectangular Waveguide: Part I, Theory,” Tech. Rep., Rantec Report No. 72022-TN-1, Rantec, Calabasas, CA, USA.
[13]. Oliner, A. A., “The impedance properties of narrow radiating slots in the broad face of rectangular waveguides,” IEEE Trans. Antennas Propagat., Vol. 5, No. 1, 4–20, 1058.
[14]. Stegen, R. J., “Longitudinal shunt slot characteristics,” Hughes Technical Memorandum, No. 261, 4–20, Culver City, CA, November 1951.
[15]. D. Deslandes, L. Perregrini, P. Arcioni, M. Bressan, K. Wu, and G. Conciauro, “Dispersion characteristics of substrate integrated rectangular waveguide,” IEEE Microwave Wireless Compon. Lett., vol. 12, pp. 333–335, Sept. 2002.
