Improving the efficiency of DC-DC converters with high-order structure utilizing parasitic inductance for Li-ion battery chargers
143 viewsDOI:
https://doi.org/10.54939/1859-1043.j.mst.78.2022.49-57Keywords:
DC-DC converter; Buck converter; High-order converter; Li-ion battery; Fast charging.Abstract
This paper presents a high-order DC-DC down-converter structure using the parasitic inductance in the USB cable as an inductor for Li-ion battery chargers. The structure provides high conversion efficiency, wide conversion range similar to the conventional Buck converter. Thanks to the continuous input current, the noise and electromagnetic interference (EMI) at the input are significantly reduced. The proposed structure is evaluated with a design for a Li-ion battery charger using a 1 m USB type-C cable. Simulation results show that the achievable peak efficiency of the proposed structure is 95% which is 8% higher than that of the conventional Buck under the same conditions.
References
[1]. Youssef Ziadi and Hassan Qjidaa “A High Efficiency Li-Ion Battery LDO-Based Charger for Portable Application”, Active and Passive Electronic Components Vol. 2015.
[2]. Ouremchi, M., et al,“Li-Ion Battery Charger Based on LDO Regulator for Portable Device Power Management”, 2018 6th International Renewable and Sustainable Energy Conference (IRSEC), vol. 2019.
[3]. C.Schaef and J. T. Stauth,“A highly integrated series–parallel switchedcapacitor converter with 12 V input and quasi-resonant voltage-mode regulation”, IEEE J. Emerg. Sel. Topics Power Electron, vol. 6, no. 2 (2018), pp. 456–464.
[4]. W. Liu, P. Assem, Y. Lei, P. K. Hanumolu “A 94.2%-peak-efficiency 1.53 A direct-battery-hook-up hybrid Dickson switched-capacitor DC-DC converter with wide continuous conversion ratio in 65 nm CMOS”, in IEEE Int. Solid-State Circuits Conf. (ISSCC),Dig. Tech. Papers, Feb. 2017, pp. 182–183.
[5]. R. Das, G.-S. Seo, and H.-P. Le, “A 120V-to-1.8V 91.5%-efficient 36W dual-inductor hybrid converter with natural soft-charging operations for direct extreme conversion ratios”, in Proc. IEEE Energy Convers. Congr.Expo. (ECCE), Sep. 2018, pp. 1266–1271.
[6]. P. Renz, M. Kaufmann, M. Lueders, and B. Wicht, “8.6 A fully integrated 85%-peak-efficiency hybrid multi ratio resonant DC-DC converter with 3.0-to-4.5V input and 500μA-to-120 mA load range load range,” in IEEE Int. Solid-State Circuits Conf. (ISSCC) Dig. Tech. Papers, Feb. 2019, pp. 156–158.
[7]. J. S. Rentmeister, C. Schaef, B. X. Foo, and J. T. Stauth, “A flying capacitor multilevel converter with sampled valley-current detection for multi-mode operation and capacitor voltage balancing,” in Proc. IEEE Energy Convers. Congr. Expo. (ECCE), Sep. 2016, pp. 1–8.
[8]. Pilawa-Podgurski, D. J. Perreault, “Merged two-stage power converter with soft charging switched-capacitor stage in 180 nm CMOS,” IEEE J. Solid-State Circuits, vol. 47, no. 7 (2012), pp. 1557–1567.
[9]. . M. Sun, Z. Yang, K. Joshi, D. Mandal, P. Adell, and B. Bakkaloglu “A 6 A, 93% peak efficiency, 4-phase digitally synchronized hysteretic buck converter with ±1.5% frequency and ±3.6% current-sharing error,” IEEE J. Solid-State Circuits, vol. 52, no. 11 (2017), pp. 3081–3094.
[10]. S. J. Kim, R. K. Nandwana, Q. Khan, R. C. N. Pilawa-Podgurski, and P. K. Hanumolu, “A 4-phase 30–70 MHz switching frequency buck converter using a time-based compensator,” IEEE J. Solid-State Circuits, vol. 50, no. 12 (2015), pp. 2814–2824.
[11]. Abdulslam, "A Passive-Stacked Third-Order Buck Converter with Inherent Input" IEEE Solid-State Circuits Letters, vol. 2, no. 11 (2019), pp. 240-243.
[12]. Hanh-Phuc. Le, Gab-Su Seo, "An Inductor-Less Hybrid Step-Down DC-DC Converter Architecture for Future Smart Power Cable," Proc. IEEE Appl. Power Electron. Conf. Expo (2018), pp. 247-253.
[13]. Hanh-Phuc. Le, Gab- Su Seo, "S-Hybrid Step-Down DC–DC Converter-Analysis of Operation and Design Considerations" IEEE Transactions of Industrial Electronics, vol. 67, no. 1, pp. 265-275, 2020.
[14]. J. Duncan Glover, Thomas J. Overbye, Mulukutla S. Sarma, “Power System Analysis and Design”, Cengage Learning (2017), pp. 161-188.
[15]. Nguyen Van Hao, Nguyen Duc Minh, Pham Nguyen Thanh Loan, “An Adaptive and Wide-Range Output DC-DC Converter for Loading Circuit of Li-Ion Battery Charger”, VNU Journal of Science: Comp. Science & Com. Eng, Vol. 34, No. 1 (2018) 10-18.
[16]. Fouad Farah, et al, “A new Li-ion battery charger with charge mode selection based on 0.18 um CMOS for phone applications”, International Journal of Electrical and Computer Engineering (IJECE), Vol. 11, No. 3, June 2021, pp. 1994~2002.
