A highly linear wide bandwidth down-conversion mixer for direct-conversion receivers in CMOS
285 viewsDOI:
https://doi.org/10.54939/1859-1043.j.mst.81.2022.44-52Keywords:
Direct-conversion receiver; Passive mixer; Current-to-voltage amplifier; High linearity; Wide baseband bandwidth.Abstract
This paper presents the down-conversion mixer in the direct-conversion receivers for new generation communication systems such as LTE and sub-6 GHz 5G. A current-controlled dual-balanced passive mixer combines with a local oscillator (LO) signal that positive pulse width is 1/4 the signal cycle (25% duty cycle) to reduce noise and improve conversion gain. A transimpedance amplifier (TIA) circuit based on a self-bias current-reuse inverter circuit is proposed to achieve high linearity and wide bandwidth simultaneously. The mixer is designed on 28 nm CMOS technology. Post-layout simulation results illustrate that the mixer has a conversion gain variation of 0.45 dB per 100 MHz in a baseband bandwidth of 580 MHz. The noise figure (NF) is 9.2 dB. The two-order input intercept point (IIP2) and the three-order input intercept point (IIP3) is 23.6 dBm and 61.5 dBm, respectively. The circuit consumes power of 40.1 mW with a supply voltage of 0.9 V whereas it occupies an area of 0.023 mm2.
References
[1]. 3GPP, 3rd-Generation Partnership Project; Technical Specification Group Radio Access Network; NR; User Equipment (UE) radio transmission and reception; Part1: Range 1 Standalone (Release 15), 3GPP TS 38.101 V15.6.0, June, (2019).
[2]. Technical Specification: 5G NR User Equipment (UE) Radio Transmission and Reception; Part 1: Range 1 Standalone, Release 15, V. 15.2.0, document 3GPP TS 38.101-1, Jul., (2018).
[3]. B. Razavi, RF Microelectronics, 2nd ed. Englewood Cliffs, NJ: Prentice-Hall, (2011).
[4]. Y. Gao, F. Huang, L. Wu and J. Cheng, “A low-power reconfigurable mixer for MB-OFDM UWB receivers,” in Asia Pacific Conference on Postgraduate Research in Microelectronics and Electronics (PrimeAsia), pp. 97-100, (2009). DOI: https://doi.org/10.1109/PRIMEASIA.2009.5397437
[5]. J. Gou, X.-Y. Xu and X.-G. Huang, "Design of a Low-Voltage CMOS Mixer with Improved Linearity", in International Conference on IC Design and Technology (ICICDT), (2019). DOI: https://doi.org/10.1109/ICICDT.2019.8790840
[6]. A. Katarmal, A. Mecwan, and M. Patel, "RF CMOS Double Balanced Gilbert Cell Mixer for 5G Application", in 3rd International Conference on Signal Processing and Communication (ICPSC), (2021). DOI: https://doi.org/10.1109/ICSPC51351.2021.9451815
[7]. M. Kashani, M. Asghari, M. Yavari, and s. Mirabbasi, "A +7.6 dBm IIP3 2.4-GHz Double-Balanced Mixer with 10.5 dB NF in 65-nm CMOS", IEEE Transactions on Circuits and Systems-II: Express Briefs, vol. 64, no. 10, pp. 3214 – 3218, April, (2021). DOI: https://doi.org/10.1109/TCSII.2021.3072487
[8]. A. Nejdel, M. Abdulaziz, M. Törmänen, and H. Sjöland, “A positive feedback passive mixer-first receiver front-end,” in Proc. IEEE Radio Freq. Integr. Circuits Symp., pp. 79-82, Jun., (2015). DOI: https://doi.org/10.1109/RFIC.2015.7337709
[9]. S. Krishnamurthy and A. M. Niknejad, “Design and Analysis of Enhanced Mixer-First Receivers Achieving 40-dB/decade RF Selectivity,” IEEE Journal of Solid-State Circuits, vol. 55, no. 5, pp. 1165–1176, (2020). DOI: https://doi.org/10.1109/JSSC.2019.2956887
[10]. Qaiser Nehal, “Low power mixer-first receiver with second-order baseband filtering TIA,” in IEEE 63rd International Midwest Symposium on Circuits and Systems (MWSCAS), (2020). DOI: https://doi.org/10.1109/MWSCAS48704.2020.9184430
[11]. Hyungjoo Seo, and Jin Zhou, “A Passive-Mixer-First Acoustic-Filtering Superheterodyne RF Front-End,” IEEE Journal of Solid-State Circuits, vol. 56, no. 5, May, (2021). DOI: https://doi.org/10.1109/JSSC.2021.3067664
[12]. B. Razavi, “The Transimpedance Amplifier,” IEEE Solid-State Circuits Magazine, vol. 11, no. 1, Winter, (2019). DOI: https://doi.org/10.1109/MSSC.2018.2881860
[13]. N. Kim, V. Aparin, and L. E. Larson, "A resistively degenerated wide-band passive mixer with low noise figure and +60 dBm IIP2 in 0.l8 µm CMOS," IEEE Radio Frequency Integrated Circuits Syposium, pp.185-188, June, (2008).
[14]. D. Kaczman, M. Shah, M. Alam, M. Rachedine, D. Cashen, L. Han, and A. Raghavan, “A single-chip 10-Band WCDMA/HSPA 4-band GSM/EDGE SAW-less CMOS receiver with DigRF 3G interface and +90 dBm IIP2,” IEEE Journal of Solid-State Circuits, vol. 44, no. 3, pp. 718–739, Mar., (2009). DOI: https://doi.org/10.1109/JSSC.2009.2013762
[15]. A. Mirzaei, H. Darabi, J. Leete, and Y. Chang, “Analysis and optimization of direct-conversion receivers with 25% duty-cycle current-driven passive mixers,” IEEE Trans. Circuits Syst. I, Reg. Papers, vol. 57, No. 9, pp. 2353–2366, Sep., (2010). DOI: https://doi.org/10.1109/TCSI.2010.2043014
[16]. P. K. Sharma and N. Nallam, “Linearity and NF tradeoff in input matched N-path mixer-first receivers with shunt-feedback TIAs,” in Proc. IEEE Int. Symp. Circuits Syst. (ISCAS), pp. 1–4, May, (2019). DOI: https://doi.org/10.1109/ISCAS.2019.8702176
[17]. J. Jiang, J. Kim, A. Karsilayan, and J. Silva-Martinez, “A 3–6-GHz Highly Linear I-Channel Receiver With Over +3.0-dBm In-Band P1dB and 200-MHz Baseband Bandwidth Suitable for 5G Wireless and Cognitive Radio Applications,” IEEE Transactions on Circuits and Systems–I: Regular Papers, vol. 66, no. 8, August, (2019). DOI: https://doi.org/10.1109/TCSI.2019.2909115
[18]. A. N. Bhat, R. van der Zee, S. Finocchiaro, F. Dantoni, and B. Nauta, “A baseband-matching-resistor noise-canceling receiver architecture to increase in-band linearity achieving 175 MHz TIA bandwidth with a 3-stage inverter-only OpAmp,” in Proc. IEEE Radio Freq. Integr. Circuits Symp. (RFIC), Boston, MA, USA, pp. 155-158, Jun., (2019). DOI: https://doi.org/10.1109/RFIC.2019.8701843
[19]. A. Martin: “Cadence Design Environment”, New Mexico State University, Oct., (2002).
