A designing solution for bandpass filter using TE dual-mode resonator in waveguides
335 viewsDOI:
https://doi.org/10.54939/1859-1043.j.mst.77.2022.30-38Keywords:
Bandpass filter; TE dual-mode.Abstract
The article presents a design for a bandpass filter using TE dual-mode resonator. The design is based on the general scatting matrix of each discontinuity in the structure. Different propagation modes in the same waveguide section are used to represent the matrices to facilitate the design. On the basis of ultra-high frequency theory and simulation software tools, the authors have calculated the design of a 4th order bandpass filter using the resonances, and with two symmetrical transmission zeros.
References
[1]. A. E. Atia and A. E. Williams, “New types of bandpass filters for satellite transponders,” COMSAT Tech. Rev., 1971.
[2]. A. E. Atia and A. E. Williams, “Narrow bandpass waveguide filters,” IEEE Trans. Microw. Theory Tech., 1972.
[3]. H. C. Chang and K. Zaki, “Evanescent-mode coupling of dual-mode rectangular waveguide filters,” IEEE Trans. Microw., 1991
[4]. S. B. Cohn, “Direct coupled resonator filters,” Proc. IRE, 1957
[5]. George L. Matthael, “Microwave Filters, Impedance Matching network and Coupling Structure”, Artech House,1985
[6]. Jijesh J.J, “Design and Development of Band Pass Filter for X-Band Radar Receiver System” 2017
[7]. https://www.3ds.com/products-services/simulia/products/cst-studio-suite/
[8]. A. E. Atia and A. E. Williams, “A solution for narrow-band coupled cavities”, COMSAT Laboratories Tech. Memo, CL-39-70, Sept.22,1970.
