Synthesis of polyamide-based RO membranes for saline water treatment

12 views

Authors

  • Nguyen Thi Anh Huy Faculty of Chemical Engineering, Ho Chi Minh City University of Technology
  • Duong Minh Triet Institute for Tropical Technology and Environmental Protection, Academy of Military Science and Technology
  • Tran Thanh Viet Institute for Tropical Technology and Environmental Protection, Academy of Military Science and Technology
  • Tran Van Cuong Institute for Tropical Technology and Environmental Protection, Academy of Military Science and Technology
  • Pham Quoc Nghiep Institute for Tropical Technology and Environmental Protection, Academy of Military Science and Technology
  • Le Anh Kien (Corresponding Author) Institute for Tropical Technology and Environmental Protection, Academy of Military Science and Technology

DOI:

https://doi.org/10.54939/1859-1043.j.mst.FEE.2024.226-230

Keywords:

Reverse osmosis; Polyamide membranes; Synthesis conditions; Surface morphology; Salt rejection.

Abstract

Reverse osmosis (RO) technology is a widely used method for converting seawater into fresh water, known for its high efficiency and broad applications. This study focuses on optimizing the synthesis conditions for polyamide (PA) membranes, including the concentrations of m-phenylenediamine (MPD) and trimesoyl chloride (TMC), the choice of solvent, soaking time, and reaction time. FTIR and SEM analysis confirmed the successful synthesis of the PA layer and revealed that the surface morphology of the membrane was significantly influenced by synthesis conditions. Mechanical testing demonstrated that the optimized membranes exhibited high tensile strength (41.18 MPa) and low elongation at break (11.69%), indicating a robust but relatively brittle material. The study determined that the optimal conditions were 1.0 wt.% MPD and 0.1 wt.% TMC, hexane as a solvent, a soaking time of 2 min, and a reaction time of 60 sec, achieving a maximum salt rejection of 86.45%. These findings are critical for enhancing RO membrane efficiency and addressing the global demand for clean water.

References

[1]. S. K. Patel et al., "The relative insignificance of advanced materials in enhancing the energy efficiency of desalination technologies," Energy & Environmental Science, vol. 13, no. 6, pp. 1694-1710, (2020). DOI: https://doi.org/10.1039/D0EE00341G

[2]. W. Xie et. al., "Polyamide interfacial composite membranes prepared from m-phenylene diamine, trimesoyl chloride and a new disulfonated diamine," J. of Membrane Science, vol. 403, pp. 152-161, (2012). DOI: https://doi.org/10.1016/j.memsci.2012.02.038

[3]. R. J. Petersen, "Composite reverse osmosis and nanofiltration membranes," Journal of membrane science, vol. 83, no. 1, pp. 81-150, (1993). DOI: https://doi.org/10.1016/0376-7388(93)80014-O

[4]. M. Namvar-Mahboub and M. Pakizeh, "Optimization of preparation conditions of polyamide thin film composite membrane for organic solvent nanofiltration," Korean Journal of Chemical Engineering, vol. 31, pp. 327-337, (2014). DOI: https://doi.org/10.1007/s11814-013-0213-6

[5]. K. P. Lee, T. C. Arnot, and D. Mattia, "A review of reverse osmosis membrane materials for desalination—Development to date and future potential," Journal of Membrane Science, vol. 370, no. 1-2, pp. 1-22, (2011). DOI: https://doi.org/10.1016/j.memsci.2010.12.036

[6]. H. Guo, X. Tang, G. Ganschow, and G. V. Korshin, "Differential ATR FTIR spectroscopy of membrane fouling: Contributions of the substrate/fouling films and correlations with transmembrane pressure," Water Research, vol. 161, pp. 27-34, (2019). DOI: https://doi.org/10.1016/j.watres.2019.05.086

[7]. C. Y. Lai et al., "Investigation of the dispersion of nanoclays into PVDF for enhancement of physical membrane properties," Desalination and Water Treatment, vol. 34, no. 1-3, pp. 251-256, (2011). DOI: https://doi.org/10.5004/dwt.2011.2888

[8]. F. G. Alabtah, A. Alkhouzaam, and M. Khraisheh, "New insights into the mechanical behavior of thin-film composite polymeric membranes," Polymers, vol. 14, no. 21, p. 4657, (2022). DOI: https://doi.org/10.3390/polym14214657

[9]. M. Ashraf et al., "Synthetic polymer composite membrane for the desalination of saline water," Desalination and Water Treatment, vol. 51, no. 16-18, pp. 3650-3661, (2013). DOI: https://doi.org/10.1080/19443994.2012.751152

[10]. H. Zhu, B. Yuan, and Y. Li, "Preparation and Desalination of Semi-Aromatic Polyamide Reverse Osmosis Membranes (ROMs)," Polymers, vol. 15, no. 7, p. 1683, (2023). DOI: https://doi.org/10.3390/polym15071683

[11]. W. Choi et al., "Thin film composite reverse osmosis membranes prepared via layered interfacial polymerization," Journal of Membrane Science, vol. 527, pp. 121-128, (2017). DOI: https://doi.org/10.1016/j.memsci.2016.12.066

[12]. H. Meng, B. Gong, T. Geng, and C. Li, "Thinning of reverse osmosis membranes by ionic liquids," Applied surface science, vol. 292, pp. 638-644, (2014). DOI: https://doi.org/10.1016/j.apsusc.2013.12.025

Downloads

Published

06-12-2024

How to Cite

Nguyen Thi Anh Huy, Duong Minh Triet, Tran Thanh Viet, Tran Van Cuong, Pham Quoc Nghiep, and Le Anh Kien. “Synthesis of Polyamide-Based RO Membranes for Saline Water Treatment”. Journal of Military Science and Technology, no. FEE, Dec. 2024, pp. 226-30, doi:10.54939/1859-1043.j.mst.FEE.2024.226-230.

Issue

Section

Chemistry, Biology & Environment

Most read articles by the same author(s)